Home | Register | Login | Inquiries | Alerts | Sitemap |  

Advanced Search
J Korean Acad Pediatr Dent. 2001;28(1): 118-128.
백병주, 양정숙, 이두철, 김재곤
전북대학교 치과대학 소아치과학교실
Share :  
This study was performed to evaluate the toothbrush abrasion characteristics of seven commercially available light-cured cervical restorative materials one resin-modified glass-ionomer material(Fuji II LC) three polyacid-modified composites(Compoglass, Dyract, F2000), and three light-cured composites(Heliomolar, Palpique Estelite, UniFil F). All samples were stored in distilled water at 37℃ for 10 days. 2.0N of weight was loaded during the test and the abraded surfaces were examined with profilometer and SEM after 100,000 cycles. The results obtained were summarized as follows; 1. The highest hardness value of 79.7 was observed in the FT group and the lowest value of 20.0 was observed in the HM group. Results of Tukey test showed that an overall significant difference was indicated except the CG and DR groups(p<0.05). 2. The highest surface roughness was observed in the FL group and the lowest was observed in the UF group. Results of Tukey test showed the significant difference between the FL or FT and UF groups(p<0.05). 3. Statistically higher abrasion and surface roughness were observed for the dentifrice of paste type, Perio A+, than for that of gel paste type, Tom & Jerry. 4. The surface roughness values increased on the abraded surfaces because of the protrusion of filler particles due to selective removal of matrix resin.
Keywords: Abrasion characteristics | Toothbrush | Surface roughness | Hardness value
Editorial Office
Seoul National University, Dental Hospital, B1-166 101, Daehak-ro, Jongno-gu, Seoul, 110-744
Tel. +82-70-4145-8875,    Fax. +82-2-745-8875   E-mail : kapd59@kapd.org

Copyright© Korean Academy of Pediatric Dentistry. All right reserved.                powerd by m2community
About |  Browse Articles |  Current Issue |  For Authors and Reviewers